Remove VoIP Setting for PowerConnect 5448 Switch as Recommended by Equallogic
I was told Power Connect 52xx/54xx series switches are optimized for VoIP and they are no longer recommended by Equallogic as 50% of the available buffers are reserved for VoIP unless you change the setting and REBOOT the switch.
I haven’t tried the following VoIP setting recommended by EQL as I don’t want to mess around my optimized configuration file.
Besides, I think there is an alternative way which I’ve completely disabled VoIP setting using PowerConnect 5448 GUI. There is a check for you to disable VoIP in the Switch session under the GUI.
Go to each switch and do the following:
Put the switch into admin and configuration mode.
enable
configure
Disable/remove iSCSI and VoIP optimization
voice vlan oui-table remove 00036b
voice vlan oui-table remove 00096e
voice vlan oui-table remove 0001e3
voice vlan oui-table remove 000fe2
voice vlan oui-table remove 0060b9
voice vlan oui-table remove 00d01e
voice vlan oui-table remove 00e075
voice vlan oui-table remove 00e0bb
Exit from configuration mode
exit
Save the configuration
copy running-config startup-config
When ready, type ‘reload’ to reboot
reload
